Put flat burrs into your Niche grinder!

Lots of people have been asking about a second run, so here it is! Another small batch will be produced to further widen the testing audience of this kit. There are so many variables to play with. Burr size, burr geometry, wiper design, materials, coatings and everything else in between and beyond... This is just the beginning.

Check out the installation video to see how quick and easy it is to do the swap.

Kit includes aluminum upper and lower burr carriers and burr screws. This time, burr sets will be sold separately or you can source your own.

By popular demand, the 58mm kit is being made alongside the 54mm. Please note that while the SSP MP burr set can grind for espresso, it is better suited for filter brewing.

Direct replacement motors (60% higher max RPM, 65% higher max torque) available by request.

Precision hopper/grind adjuster available here

I will update this page as I release my own burrs. Photos show examples of the current development.

Many have asked about Ditting burrs, you can supply your own but the motor spin direction must be reversed - simple swapping the positive and negative wire position on the motor connector.

Please read the disclaimers below before ordering.

Disclaimer:

• This item is not affiliated with Niche
• Use this item at your own risk. By performing this conversion, you must accept that your grinder may wear out, incur damage or stop working for any reason quicker than originally configured